SETUP STEP: Turn on GPS until you get a green status on any activity to save your last position and everything will be fine. Starting a run/walk should do it. No need to save the activity but times are calculated based on your GPS location for accurate results.
The activation code will be immediately accessible on the checkout page. You will also receive the activation code typically in less than 5 mins (*Please verify your spam folder).
Entering the activation code in the settings section will allow the paid options to be applied.
A: Please write me! Use the contact developer option on this page before leaving a bad review!
Q: How do I change between 12/24 hour?
A: This can be changed in the watch face settings.
Q: How does Dynamic Fields work?
A: Dynamic fields are displayed when the watch is in "High power" mode. Bringing your arm up and to your face will do just that. (Looking at your watch) This behaviour is detected by the watch and not the watch face. During that time, the watch will update more frequently for a few seconds. I'm using this time to cycle between the primary data and the dynamic data. *Currently, it will show your primary data for 1 seconds before changing... so try holding the position for a few seconds.
If you want the data to stay the same, you will need to set both the field1 and dynamic field1 to the same value.